Digi AnywhereUSB Plus User Manual

System administration Disable device encryption
AnywhereUSB® Plus User Guide
435
Disabling device encryption is not available in the WebUI. It can only be performed from the Admin
CLI.
Command line
1. Log into the AnywhereUSB Plus command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Disable encryption with the following command:
> system disable-cryptography
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Re-enable cryptography after it has been disabled.
To re-enable cryptography:
1. Configure your PC network to connect to the 192.168.210 subnet. For example, on a Windows
PC:
a. Select the Properties of the relevant network connection on the Windows PC.

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English