Interfaces Local Area Networks (LANs)
AnywhereUSB® Plus User Guide
183
d. Modify any of the remaining default settings as appropriate. For example, to change the
minimum length of the prefix:
(config network interface my_lan)> ipv6 prefix_length 60
(config network interface my_lan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
(Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MACaddress to the denylist:
(config network interface my_lan)> add mac_denylist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MACaddress.
(Optional) Configure the MAC address allowlist.
If there allowlist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Add a MACaddress to the allowlist:
(config network interface my_lan)> add mac_allowlist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MACaddress.
8. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show LAN status and statistics
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
To Next Page
Loading...
Need help?
General