GE MP100 Series User Manual

6-18 CIC Pro™ 2026419-033E
Configuration
4. Click Save to save your changes.
Enable or disable the Remote Service Agent
After the CIC Pro center has been configured for remote serviceability, this option
must be enabled for use.
1. If you have not already logged onto Webmin, Log on to the Webmin service
interface on page 4-7.
2. Click Configuration > Remote Service > Control.
3. On the Remote Service Controls screen, select the appropriate option in the New
State field:
Enterprise URL If required, designate the address
of the GE backoffice servers
required to communicate with the
Remote Service agent.
This address is typically
preconfigured to connect to the
Remote Back Office, but it can
be edited to suit customer
requirements.
Enterprise Tunnel
URL
If required, designate the address
of the GE backoffice servers
required to communicate with the
tunneling agent.
Protocol Identifies the protocol used to
communicate with the enterprise
servers.
This field is read-only and
cannot be changed.
Remote Desktop Enable a remote screen-sharing
for a GE Technical Support view
of the two clinical displays for
diagnosing problems with the CIC
Pro center or CARESCAPE
Network.
This a view-only option. If No
is selected, then GE Technical
Support will not be able to view
the displays.
Remote Service Configuration
Parameter Value Notes

GE MP100 Series Specifications

General

Brand	GE
Model	MP100 Series
Category	Medical Equipment
Language	English