7-10 CIC Pro™ 2026419-033E
Checkout procedures
4. Print a one-hour full disclosure report.
a. Set the Start and End time.
b. Set the Time Per Line time duration.
c. Click Print.
5. Verify the full disclosure report printed out at the printer.
6. Repeat for every CIC Pro center in the care unit.
Save backup defaults file on the USB memory stick
Ensure that you have backed up the CIC defaults file on the USB memory stick. See
Back up and restore the CIC Pro center configuration on page 6-71.
FRU checkout procedures
Check read and write integrity of hard drive and solid state flash
drive
The following table lists the drives/partitions on the CIC Pro center hardware:
NOTE
The CIC Pro center application must be stopped before you can check for disk
errors on a disk drive.
CAUTION
During shutdown or while in administrator mode, beds displayed by
the CIC Pro center will be unmonitored if not displayed by a
different CIC Pro center.
1. Log on to the CIC Pro center as Administrator on page 4-3.
2. From the Windows taskbar, click Start > Run.
3. At the command prompt, type cmd.
4. At the D:\> prompt, type chkdsk and press Enter.
Drive/partition Contents
C Clinical application and service application
DOS1
F Configuration data
G FD data
To Next Page
Loading...
Need help?
General
