11-8 CIC Pro™ 2026419-033E
Reload software
Check proper operation
NOTE
The Log Compression Configuration Utility must be run:
After upgrading to CIC Pro center software v5.1.x
When a CIC Pro center v5.1.x is added to an existing Multimouse group
Initial configuration of any CIC Pro center v5.1 device during new installs
During CIC Pro center v5.1 configuration after software re-image/ reload
process
To verify proper operation in the patient care and networking environments, complete
all of the checkout procedures identified in Complete configuration checkout
procedures on page 6-91.
Reload process troubleshooting
If the system doesn’t boot from the USB stick, then there could be one or more of the
following problems.
Incorrect boot order
The correct boot order is:
USB-HDD
HDD-2
IBA GE Slot 010
The correct boot order can be set by completing the load optimized defaults procedure
as follows:
NOTE
Correcting the boot order is a password protected process. The password is
8765309.
1. Press Ctrl + Alt + Delete to restart the system. Watch for the processor type to
appear and IMMEDIATELY press Delete to enter the BIOS setup utility.
2. Select Load Optimized Defaults by using the up/down arrow keys to and press
Enter.
3. Type Y and press Enter at the Load Optimized Defaults (Y/N)? prompt.
4. Press F10 to save the settings.
5. Type Y and press Enter at the Save to CMOS and EXIT (Y/N)? prompt.
6. Allow the computer to automatically start up.
To Next Page
Loading...
Need help?
General
