6-36 CIC Pro™ 2026419-033E
Configuration
Restart CIC Pro center
NOTE
If you have completed Set the time zone on page 6-34, it is not necessary to
restart the CIC Pro center again at this point.
Restart the CIC Pro center. From the Windows taskbar, click Start > Shutdown >
Restart and press Enter.
Configure clinical application settings
Configure the printer settings
1. If you are printing to a laser printer, configure the print settings for the laser
printer:
a. Install a network laser printer on page 6-14.
b. Set the laser printer default paper size on page 6-30.
c. Configure the CIC Pro center’s Printer/Writer settings on the CIC Defaults
window. See Set the CIC Defaults on page 6-36.
2. If you are printing to the bedside patient monitor’s default printer, verify the
correct printer is selected in the Print Window field under Graph Setup on the
Telemetry Unit Defaults window. See Set the Telemetry Unit Defaults on page 6-
44.
Configure clinical application, telemetry, and care unit settings
This section describes the procedures required to configure the clinical application,
telemetry, and care unit settings protected by the Service mode password.
Set the CIC Defaults on page 6-36.
Set the Telemetry Unit Defaults on page 6-44.
Set the full disclosure defaults on page 6-47.
Set the Display Configuration (non-mirror CIC Pro centers) on page 6-49.
Set the Current Telemetry Listings on page 6-51.
Set the CIC Defaults
1. From the multi-patient viewer, click Setup CIC.
2. Log on to Setup CIC with service access on page 4-5.
To Next Page
Loading...
Need help?
General
