Configuration
2026419-033E CIC Pro™ 6-67
Configure the print location settings for stored
patient data
Overview
You can configure specific categories of non-real-time patient data to print to a local
laser printer or to the bedside patient monitor’s current Print Window configuration.
You can also prevent non-real-time patient data from being printed by disabling the
CIC Pro center’s menu bar print button.
NOTE
The patient data categories available to print are determined by the licensed
features and functions activated on your CIC Pro center.
You must configure the laser printer and bedside monitor print settings
before you can configure the print location of the patient data categories.
The bedside monitor only prints the categories of patient data it supports.
Consult with your CAS or hospital staff about the use of this function and if
it should be used with your configuration.
Configure the print location settings for the patient data categories
1. Make sure the print settings are configured for the laser printer and bedside
patient monitor’s default printer.
2. If you have not already logged onto Webmin, Log on to the Webmin service
interface on page 4-7.
3. Click Configuration > Printers > Config Func Location.
NOTE
When configuring printing for Graphic Trends, do not use Bedside
Determined. Use Local Laser. This will use the local CIC Pro center laser
printer and print in landscape mode. Using Bedside Determined for Graphic
Trends prints in portrait mode but not all time ranges work in portrait mode.
The Graphic Trends time ranges are the choices in the dropdown menu (e.g.
12hr, 4hrs, 24hrs, etc.).
To Next Page
Loading...
Need help?
General
