EasyManuals Logo
Home>GE>Medical Equipment>MP100 Series

GE MP100 Series User Manual

GE MP100 Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #123 background imageLoading...
Page #123 background image
Configuration
2026419-033E CIC Pro™ 6-29
used as a USB printer, they do not require any special installation. As long as the
printer is connected to the CIC Pro center, it is readily available for configuration at
the CIC Setup.
Configure HP LaserJet P3015 USB printers
MP100 series hardware running CIC Pro center v5.1.x software supports the HP
LaserJet P3015 printer as a plug and play USB printer and as a Network printer. This
printer, when used as a USB printer, requires special installation/configuration as
described in this section.
1. Log on to the CIC Pro center as Administrator on page 4-3.
2. Power up the printer to be installed.
3. Connect the supplied printer USB cable to the USB port on the printer and then
to the USB port on the CIC Pro center.
4. When the Found New Hardware Wizard window displays, select No, not this
time and select Next to continue.
5. Select Install from a list or specific location (Advanced) and select Next to
continue.
6. Select Don’t search. I will choose the driver to install and select Next to
continue.
7. Select DOT4 USB Printing Support and select Next to continue.
8. Select Finish. After approximately 2 minutes, the Found New Hardware Wizard
window will display. This wizard allows the installation of the generic IEEE
1284.4 printing support.
9. Select Install from a list or specific location (Advanced) and select Next to
continue.
10. Select Don’t search. I will choose the driver to install and select Next to
continue.
11. Select Printers as the Hardware type and select Next to continue.
12. Select HP as the Manufacturer and HP Universal Printing PS as the Printer
and select Next to continue.
13. Select Ye s to the Update Driver Warning message. The installation will take a
few minutes.
14. When prompted, select Finish.
15. From the CIC Pro center desktop, select Start > Settings > Printers and Faxes.
16. In the Printers and Faxes window, rename the USB printer you just installed as
needed to designate it as a USB printer (i.e., HP LaserJet P3015 USB).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE MP100 Series and is the answer not in the manual?

GE MP100 Series Specifications

General IconGeneral
BrandGE
ModelMP100 Series
CategoryMedical Equipment
LanguageEnglish

Related product manuals