11-2 CIC Pro™ 2026419-033E
Reload software
Purpose
If the CIC Pro center experiences intermittent problems, or the flash drive or hard
drive is replaced, you may need to re-image either the hard drive or flash drive. Refer
to the following table for instructions:
Process overview
This section describes the procedures required to re-image the flash or hard drive:
Gather required equipment and tools on page 11-2.
Create a CIC Pro center image restore USB memory stick on page 11-2
Reload CIC Pro center software on page 11-5.
Gather required equipment and tools
Service PC (desktop or laptop computer) equipped with a DVD drive, and
running Windows NT, 2000, or XP.
This manual.
CIC v5.1.x Image DVD supplied via the CIC v5.1.x software reload/disaster
recovery kit.
USB memory stick with a minimum of 1 GB memory.
Create a CIC Pro center image restore USB memory
stick
1. Insert the USB memory stick into a vacant USB port on the service PC.
2. Insert the DVD containing the GE Software Distribution Utility into the service
PC’s DVD drive.
3. On the GE Software Distribution Utility screen, click List USB Drive(s).
If this FRU is replaced Follow this procedure
Hard drive Re-image the hard drive. Follow the Reload CIC Pro center
software on page 11-5.
Flash drive (solid-state drive) Re-image the Flash drive. Follow the Reload CIC Pro
center software on page 11-5.
CPU PCB (mother board) Do not re-image the Flash drive or hard drive after
replacing the CPU PCB.
To Next Page
Loading...
Need help?
General
