6-16 CIC Pro™ 2026419-033E
Configuration
NOTE
If the printer is not connected to the network, then the test page will be
queued to the printer and will print after it is connected to the network.
10. Click Submit. The installed printer displays in the printer list.
Delete a network laser printer
Complete the following procedure to delete a network laser printer:
1. If you have not already logged onto Webmin, Log on to the Webmin service
interface on page 4-7.
2. Click Configuration > Printers.
3. Click Delete Laser Printer.
4. Under Select the printer to delete, select the printer you want to delete from the
drop-down list.
5. Click Submit. The printer is deleted from the printer list.
NOTE
Deleting a printer does not remove the references to it under the CIC Setup/
care unit default settings.
Configure the server for remote connectivity
The CIC Pro center is capable of remote service using GE Healthcare InSite ExC
Digital Services. See the site survey workbook for required configuration
information.
This section describes the procedures required to configure the server for remote
connectivity:
Configure the Remote Service settings on page 6-16.
Enable or disable the Remote Service Agent on page 6-18.
Configure the Remote Service settings
1. If you have not already logged onto Webmin, Log on to the Webmin service
interface on page 4-7.
2. Click Configuration > Remote Service > Configuration.
To Next Page
Loading...
Need help?
General
