Burst cycles are continuously output when the
internal trigger is selected. The burst period
determines the rate of bursts and the time between
bursts.
Burst cycle must be less than the product of the
burst period and wave frequency.
Burst Cycle < (Burst Period x Wave Frequency)
If the burst cycle exceeds the above conditions, the
burst period will be automatically increased to
satisfy the above conditions.
If gated burst mode is selected, burst cycle is
ignored. Though, if the burst cycle is changed
remotely whilst in gated mode, the new burst cycle
is remembered when used next.
To Next Page
Loading...
Need help?
General
