GW Instek MFG-2000 Series User Manual

REMOTE INTERFACE
311
SOURce[1|2|3|3RF]:PM:STATe
Source Specific
Command
Description
Turns PM Modulation on or off. By default PM
modulation is off.
Note
Burst or sweep mode will be disabled if PM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when PM modulation is enabled.
Syntax
SOURce[1|2|3|3RF]:PM:STATe {OFF|ON}
Example
SOUR1:PM:STAT ON
Enables PM modulation
Query Syntax
SOURce[1|2|3|3RF]:PM:STATe?
Return Parameter
0
Disabled (OFF)
1
Enabled (ON)
Example
SOUR1:PM:STAT?
1
PM modulation is currently enabled.
SOURce[1|2|3|3RF]:PM:SOURce
Source Specific
Command
Description
Sets or queries the PM source as internal or
external. Internal is the default source.
Note
If an external PM source is selected, the phase
modulation is controlled by the MOD INPUT
terminal on the rear panel.
The RF channel supports only the internal
modulation mode.
Syntax
SOURce[1|2|3|3RF]:PM:SOURce {INTernal|EXTernal}
Example
SOUR1:PM:SOUR INT
Sets the PM source to internal.
Query Syntax
SOURce[1|2|3|3RF]:PM:SOURce?

GW Instek MFG-2000 Series Specifications

General

Brand	GW Instek
Model	MFG-2000 Series
Category	Inverter
Language	English