GW Instek MFG-2000 Series User Manual

REMOTE INTERFACE
319
SOURce[1|2]:SUM:STATe
Source Specific
Command
Description
Turns SUM Modulation on or off. By default SUM
modulation is off.
Note
Burst or sweep mode will be disabled if SUM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when SUM modulation is
enabled.
Syntax
SOURce[1|2]:SUM:STATe {OFF|ON}
Example
SOUR1:SUM:STAT ON
Enables SUM modulation
Query Syntax
SOURce[1|2]:SUM:STATe?
Return Parameter
0
Disabled (OFF)
1
Enabled (ON)
Example
SOUR1:SUM:STAT?
1
SUM modulation is currently enabled.
SOURce[1|2]:SUM:SOURce
Source Specific
Command
Description
Sets or queries the SUM source as internal or
external. Internal is the default source.
Note
If an external SUM source is selected, the duty
cycle/pulse width is controlled by the MOD
INPUT terminal on the rear panel.
Syntax
SOURce[1|2]:SUM:SOURce {INTernal|EXTernal}
Example
SOUR1:SUM:SOUR INT
Sets the SUM source to internal.
Query Syntax
SOURce[1|2]:SUM:SOURce?

GW Instek MFG-2000 Series Specifications

General

Brand	GW Instek
Model	MFG-2000 Series
Category	Inverter
Language	English