February 2012 3 – 17
3 Code numbers
3.1 Introduction
With code numbers …
îš„ certain areas of the hard disk
îš„ certain file types
îš„ certain functions
... can be called.
3.2 Overview
Code numbers may only be passed on to and be used by trained service technicians.
Keep the code numbers confidential!
Inexpert handling may result in a loss of important data, in faulty machine performance and thus
lead to damage or injury to property or persons.
Code number Brief description Description in this
manual
0 Reset the previously entered code numbers --> Soft keys such as MP
EDIT or PLC EDIT are deleted.
In this chapter
123 Edit subset of machine parameters for the machine operator See page 31 – 571
75368 Offset adjustment for analog axes See page 21 – 355
79513 Info menu (U[BATT], U[ACCU], U[VCC], TEMP, T[CPU1]), See page 18 – 261
95148 Call the active machine parameter list See page 31 – 571
531210 Reset non-volatile PLC markers and PLC words in the RAM See page 11 – 134
688379 Integrated oscilloscope See page 10 – 95
807667 Call the PLC area See page 11 – 115
857282 Reset the operating times - - -
LOGBOOK Call and save the internal log of the iTNC See page 8 – 79
NET123 Network settings for the single-processor control See page 14 – 183
SETUP Call for loading service packs and NC software for the single-processor
control
See page 16 – 219
SIK Display of the number of the system identification key and of the enabled
options
See page 29 – 517
VERSION Create the file TNC:\Version.a
System data is saved in this file for diagnostic purposes. The file can be
read out for diagnosis.
- - -
Machine tool builders may define their own MP and PLC code numbers.
In this event the HEIDENHAIN code numbers do not function any longer, or only function to
a limited extent. --> Contact your machine tool builder!
To Next Page
Loading...
Need help?
General
