HEIDENHAIN iTNC 530 HSCI Service Manual

14 – 196 HEIDENHAIN Service Manual iTNC 530 HSCI
14.3 Reading in and out individual files and directories
There are several possibilities of reading in and downloading files and directories:
 Connection of a USB device; transfer using the split screen concept in the program
management
 Transfer with TNCremoNT
 Transfer using TNCserver
Connection setup
8 Connect a USB flash drive. --> See ”Connection setup” on page 14 – 183.
Or ...
8 Establish the connection between the control and the laptop using TNCremoNT.
--> See ”Connection setup” on page 14 – 183.
Transferring data to
the USB flash drive
8 Switch to the Programming and Editing operating mode (for TNC data) or to PLC programming
(for PLC data) and press the PGMMGT key.
8 Place the cursor on the USB0:\ directory.
8 If required, you can create a new directory (e.g. data backup) on the flash drive.
Enter the name of the new directory.
8 Conclude your entry with the ENT key and the YES soft key.
Note
Information on setting data interfaces and transferring data (e.g., TNCserver operation) can be
found in the User's Manual for the iTNC 530 HSCI.
Note
To change to the PLC partition you must have entered the PLC code number before.
Note
In the following description the program manager is set to Enhanced 1 mode.
--> See ”Settings in the program manager” on page 13 – 174.

HEIDENHAIN iTNC 530 HSCI Specifications

General

Brand	HEIDENHAIN
Model	iTNC 530 HSCI
Category	Control Systems
Language	English