D2 Drive User Guide v1.8 1. About the User Guide
HIWIN Mikrosystem Corp. 2
1.1. Instructions before use
This document is suitable for D2-series drives, included D2 model and D2T model. Read the
User Guide carefully before using the product. HIWIN Mikrosystem Corp. (“the Company”) will
not take any responsibility for damages, accidents, or injuries caused by the installation or use
that is not performed according to these instructions.
Do not dismantle or modify the product. The product has been subject to structural
calculations, computer simulations, and physical tastings to verify its design. Do not
dismantle or modify the product without the consent of the professional technician of the
Company. The Company does not take any responsibility for accidents or damages
resulting from such dismantling or modification.
Before installing or using the product, check the external appearance and ensure that there
is no damage on the product surface. If any damage is identified, contact the Company or
one of the Company’s distributors immediately.
Refer to performance specifications on the product label or manufacturer's document before
using the product. Install the product based on these performance limits and installation
instructions indeed.
Read the specification of power voltage on the label before using the product and confirm
that the power supply meets the product requirement. The Company does not take any
responsibility for product damages or personal injuries resulting from the incorrect power
supply.
Do not use the product over the rated load. The Company does not take any responsibility
for damages or injuries resulting from such misuse.
Do not use the product in an environment where shocks may occur. The Company does not
take any responsibility for damages, accidents, or injuries resulting from such shocks.
If the drive has any error, refer to Section 9.5. Troubleshooting for common issues. Follow
instructions to turn off drive’s power to perform troubleshooting. After the error is eliminated,
turn on drive’s power again.
Do not try to repair any produce’s malfunction. The product can only be repaired by the
qualified technician.
The warranty period is one year from the ex-factory date. The Company does not take any
responsibility for product replacement or repair caused by the inappropriate use or natural
disasters. (Refer to notes and installation instructions in the User Guide.)
‧Maximum ambient temperature for this series drives is 55 ℃.
‧This product can be installed only on the environment with the pollution level being
2.
‧The rated input voltage of drive is 240 V. Hence, the power supply voltage cannot be
over than 240 V. A short-circuit current shall not exceed 5,000 A.
‧The drive does not provide a motor over-temperature sensing, while not have a motor
over-temperature protection.
‧The short-circuit protection of drive cannot be used as a shunt-circuit protection. The
shunt-circuit protection must be chosen in accordance with US National Electrical
Code (NEC) and local regulations.
‧Before starting to inspect the product, turn off the power and wait at least five
minutes. Then, use a multi-meter or a similar instrument to check that the residual
voltage between P and N terminals has dropped to the safety level (50 Vdc or lower)
to avoid electric shock.
To Next Page
Loading...
Need help?
General
