312 Chapter 10 Appendix EN
Move and transport the printer
The precautions when moving the printer a short distance or long distance are explained.
Move the printer a short distance
Take the following precautions when moving the printer a short distance - for instance, when relocating the
printer inside the same room.
CAUTION:
• Grip the center area at the base of the printer’s sides. Lift it slowly and do not strain your body.
• Unplug the power cord from the wall outlet before you move the printer. While moving the printer, take
care that the power cord is not damaged under the printer. Failing to take these precautions could result in
fire or electric shock.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the
cord can damage the power cord. Use of damaged power cords could result in fire or electric shock.
IMPORTANT:
• Be sure to keep the printer level. If it is unduly tilted, ink will leak from the ink cartridge.
1. Press and hold down
(the Power button) until it turns off, and then unplug the power cord.
2. Disconnect the USB cable or Ethernet cable.
3. Lift the printer and move it to the place where you want to install it.
Grip the indented area at the base of the printer’s sides, as shown. Lift and carry the printer slowly and
carefully.
NOTE:
• When you move the printer, unplug the power cord from the printer, too.
• Make sure the power cord is not trapped under the printer.
To Next Page
Loading...
Need help?
General