768 Data Collection and Analysis
The sensor is displayed in the Meter View and is available for set up
options.
The following is an example of an offline motion detector sensor in
Meter View.
Selecting a remote collection unit
Only the TI-Nspire™ Lab Cradle, TI CBR 2™, and Vernier Go!Motion®
support remote data collection.
Parameters for collection setup will use current values. Desired edits must
be performed before this procedure. See Setting and using a collection
mode.
To select the collection unit:
1. Set up your experiment for data collection.
2. Select
Experiment > Advanced Set Up > Remote Collection.
3. Select the data collection device you want to use from the drop-down
list.
To Next Page
Loading...
Need help?
General
