Dräger Infinity Kappa User Manual

7-10 DELTA/DELTA XL/KAPPA VF8
7 R
ECORDINGS
To assign recorders
1. Press the Menu fixed key to display the Main menu.
2. Click on
Monitor Setup.
3. Click on Recordings.
4. Click on
R50 Assign. A data entry window appears.
5. Scroll through the numbers and click successively on the single digits of the
clinical password. If you make a mistake, click on
Backspace and try again.
6. Click on
Accept to open the R50 Assign menu.
7. Click on
Primary Recorder to display available recorders.
8. Click on the desired recorder.
9. Click on
Secondary Recorder.
10. Click on the desired recorder.
Replacing Recorder Paper
When the recorder is about to run out of paper, a red line appears on the recording
strip. Replace the paper as soon as possible to provide continued operation.
To replace the recorder paper:
1. Open the paper door.
2. Pull out the paper roll from the spool holder.
3. Remove any paper remaining in the printing mechanism.
4. Place the new paper roll into the spool holder. Unroll a few inches of paper
from the bottom. The printed side should be facing up.
5. Align the paper roll with paper guides. If not aligned, paper could jam.
6. Close the paper door.
7. To verify positive results, generate a timed recording (see page 7-6).
NOTE:
 Recorder names are assigned by DrägerService when the Infinity network is
configured.
 If your monitor and recorders are not networked, contact DrägerService to
configure the recorder.

Dräger Infinity Kappa Specifications

General

Brand	Dräger
Model	Infinity Kappa
Category	Medical Equipment
Language	English