FIO2
VF8 DELTA/DELTA XL/KAPPA 29-11
Infinity etCO
2
Microstream SmartPod
1. To clean the pod's surfaces, lightly dampen a cloth with a 70% alcohol
solution.
2. Wipe all surfaces.
Alcohol wipes may also be used. The frequency of the cleaning procedure should be
determined by hospital policy.
FiO
2
Clean the FiO
2
sensor by wiping external surfaces with a cloth lightly dampened with
a mild detergent or isopropyl alcohol. Disinfect the external surface of the FiO
2
sensor
using a cloth moistened with ethanol.
WARNING: Do not autoclave or sterilize this device.
CAUTION:
Do not spray or pour any liquid directly on the pod, accessories or
consumables.
Do not use caustic or abrasive cleaners, or harsh solvents, including
petroleum-based or acetone solutions, to clean the device.
Microstream ® etCO
2
consumables are designed for single patient use and are
not to be reprocessed. Do not attempt to clean, disinfect, sterilize or flush out
the FilterLine as this can damage the monitor
CAUTION: Do not autoclave, gas sterilize, or irradiate the oxygen sensors. Do not
clean the sensor with chemicals other than alcohol or a mild cleaning agent.
To Next Page
Loading...
Need help?
General
