300 Chapter6
General Troubleshooting
System Analyzer Programming Errors (100 to 150)
System Analyzer Programming Errors
(100 to 150)
Refer to the HP 8560 E-Series and EC-Series Spectrum Analyzers
User's Guide for information on programming the spectrum analyzer.
100 NO PWRON Power-on state is invalid; default state is loaded. Press
SAVE, PWR ON STATE to clear error message.
101 NO STATE State to be RECALLed not valid or not SAVEd.
106 ABORTED! Current operation is aborted; HP-IB parser reset.
107 HELLO ?? No HP-IB listener is present.
108 TIME OUT Analyzer timed out when acting as controller.
109 CtrlFail Analyzer unable to take control of the bus.
110 NOT CTRL Analyzer is not system controller.
111 # ARGMTS Command does not have enough arguments.
112 ??CMD?? Unrecognized command.
113 FREQ NO! Command cannot have frequency units.
114 TIME NO! Command cannot have time units.
115 AMPL NO! Command cannot have amplitude units.
116 ?UNITS?? Unrecognizable units.
117 NOP NUM Command cannot have numeric units.
118 NOP EP Enable parameter cannot be used.
119 NOP UPDN UP/DN are not valid arguments for this command.
120 NOP ONOF ON/OFF are not valid arguments for this command.
121 NOP ARG AUTO/MAN are not valid arguments for this command.
122 NOP TRC Trace registers are not valid for this command.
123 NOP ABLK A-block format not valid here.
124 NOP IBLK I-block format not valid here.
125 NOP STRNG Strings are not valid for this command.
126 NO ? This command cannot be queried.
127 BAD DTMD Not a valid peak detector mode.
128 PK WHAT? Not a valid peak search parameter.
129 PRE TERM Premature A-block termination.
To Next Page
Loading...
Need help?
General
