Chapter 6 301
General Troubleshooting
System Analyzer Programming Errors (100 to 150)
130 BAD TDF Arguments are only for TDF command.
131 ?? AM/FM AM/FM are not valid arguments for this command.
132 !FAV/RMP FAV/RAMP are not valid arguments for this command.
133 !INT/EXT INT/EXT are not valid arguments for this command.
134 ??? ZERO ZERO is not a valid argument for this command.
135 ??? CURR CURR is not a valid argument for this command.
136 ??? FULL FULL is not a valid argument for this command.
137 ??? LAST LAST is not a valid argument for this command.
138 !GRT/DSP GRT/DSP are not valid arguments for this command.
139 PLOTONLY Argument can only be used with PLOT command.
140 ?? PWRON PWRON is not a valid argument for this command.
141 BAD ARG Argument can only be used with FDIAG command.
142 BAD ARG Query expected for FDIAG command.
143 NO PRESL No preselector hardware to use command with.
144 COUPL?? Invalid COUPLING argument, expected AC or DC.
ADC Errors (200 to 299)
These errors are directly related to the ADC/interface
section. Suspect a faulty A2 controller, A3 interface
assembly or, in 8560 E-series analyzers, the A16 fast
ADC (FADC) assembly (Option 007).
Errors 202 through 207 apply only to EC-series
analyzers and E-series analyzers with fast ADC
(Option 007).
200 SYSTEM ADC driver/ADC hardware/firmware interaction; check
for other errors.
201 SYSTEM ADC controller/ADC hardware/firmware interaction;
check for other errors.
202 FADC CAL Binary search failed during FADC linear offset
calibration.
This error applies only to EC-series analyzers and
E-series analyzers with fast ADC (Option 007)
203 FADC CAL Binary search failed during FADC log offset
calibration.
This error applies only to EC-series analyzers and
E-series analyzers with fast ADC (Option 007)
To Next Page
Loading...
Need help?
General
