Interactive SourceMeter® Instrument Reference Manual Section 3:
2450-901-01 Rev. B/September 2013 3-43
Using remote commands for configuration list operations
The following topics provide information to:
• Create an example source configuration list named MySourceList.
• Store four example configuration points on MySourceList.
• View the contents of a specific configuration point.
• Recall a configuration point from MySourceList.
The following table provides information about specific settings for each configuration point.
Settings Index 1 Index 2 Index3 Index 4
UserDelay1-5 None None None None
The figures in this section include a graphic representation of MySourceList and the four
configuration points. For simplicity, the figures will only show two of the source settings listed in the
table (source range and source level).
This example creates a source configuration list; however, you can use the same process to create a
measure configuration list.
Creating a configuration list and giving it a name
Use one of the following methods to create the configuration list used in this example and give it a
name.
Using SCPI commands:
:SOURce:CONFiguration:LIST:CREate "MySourceList"
Using TSP commands:
smu.source.configlist.create("MySourceList")
To Next Page
Loading...
Need help?
General
