To Next Page

To Previous Page

Model 2450

Interactive SourceMeter® Instrument Reference Manual Section 8:

TSP command reference

2450-901-01 Rev. B/September 2013 8-243

tspnet.reset()

This function disconnects all TSP-Net sessions.

Type TSP-Link accessible

Affected by Where saved Default value

Function

Usage

tspnet.reset()

Details

This command disconnects all remote instruments connected through TSP-Net. For TSP-enabled devices, this

causes any commands or scripts running remotely to be terminated.

Also see

None

tspnet.termination()

This function sets the device line termination sequence.

Type TSP-Link accessible

Affected by Where saved Default value

Function

Usage

type = tspnet.termination(connectionID)

type = tspnet.termination(connectionID, termSequence)

type

The termination type:

• tspnet.TERM_LF

• tspnet.TERM_CR

• tspnet.TERM_CRLF

• tspnet.TERM_LFCR

Details

This function sets and gets the termination character sequence that is used to indicate the end of a line for a

TSP-Net connection.

Using the termSequence parameter sets the termination sequence. The present termination sequence is

always returned.

For the termSequence parameter, use the same values listed in the table above for type. There are four

possible combinations, all of which are made up of line feeds (LF or 0x10) and carriage returns (CR or 0x13). For

TSP-enabled devices, the default is tspnet.TERM_LF. For devices that are not TSP-enabled, the default is

tspnet.TERM_CRLF.

Keithley 2450 User Manual

Other manuals for Keithley 2450