To Next Page

To Previous Page

Section

6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument

Reference Manual

6-42 2450-901-01 Rev. B/September 2013

[:SENSe[1]]:COUNt

This command sets the number of measurements to be performed when a measurement is requested.

Type Affected by Where saved Default value

Command and query

Recall settings

Instrument reset

Power cycle

Save settings 1

Usage

[:SENSe[1]]:COUNt <n>

[:SENSe[1]]:COUNt DEFault

[:SENSe[1]]:COUNt MINimum

[:SENSe[1]]:COUNt MAXimum

[:SENSe[1]]:COUNt?

[:SENSe[1]]:COUNt? DEFault

[:SENSe[1]]:COUNt? MINimum

[:SENSe[1]]:COUNt? MAXimum

<n>

The number of measurements (1 to 300,000)

Details

This command sets the number of measurements that are taken when a measurement is requested. This

command does not affect the trigger model.

To get better feedback from the instrument, use the Simple Loop trigger model template instead of

using the count command.

Example

COUN 10

Make ten measurements.

Also see

:MEASure:<function>? (on page 6-4)

Keithley 2450 User Manual

Other manuals for Keithley 2450