8: TSP command reference Model 2450 Interactive SourceMeter® Instrument
8-178 2450-901-01 Rev. B/September 2013
Example
trigger.lanin[1].edge = trigger.EDGE_FALLING
Set the edge state of LAN event 1 to
Also see
Digital I/O (on page 3-62)
TSP-Link system expansion interface (on page 3-118)
trigger.lanin[N].overrun
This attribute contains the overrun status of the event detector.
Type TSP-Link accessible Affected by Where saved Default value
LAN trigger N reset
Usage
overrun = trigger.lanin[N].overrun
The trigger overrun state for the specified LAN packet (
or
)
The LAN event number (1 to 8)
Details
This attribute indicates whether an event has been ignored because the event detector was already in the
detected state when the event occurred.
This is an indication of the state of the event detector built into the synchronization line itself. It does not indicate
if an overrun occurred in any other part of the trigger model, or in any other construct that is monitoring the event.
It also is not an indication of an output trigger overrun.
Example
overrun = trigger.lanin[5].overrun
print(overrun)
Checks the overrun status of a trigger on LAN5 and
outputs the value, such as:
Also see
trigger.lanin[N].clear() (on page 8-177)
trigger.lanin[N].wait() (on page 8-179)
trigger.lanout[N].assert() (on page 8-179)
trigger.lanout[N].stimulus (on page 8-184)
To Next Page
Loading...
Need help?
General
