To Next Page

To Previous Page

Model 2450

Interactive SourceMeter® Instrument Reference Manual Section 8:

TSP command reference

2450-901-01 Rev. B/September 2013 8-199

trigger.model.setblock() — trigger.BLOCK_BRANCH_ONCE

This attribute causes the trigger model to branch to a specified building block the first time it is encountered in the

trigger model.

Type TSP-Link accessible Affected by Where saved Default value

Function

Yes

Restore configuration

Instrument reset

Power cycle

Configuration script

Not applicable

Usage

trigger.model.setblock(blockNumber, trigger.BLOCK_BRANCH_ONCE, branchToBlock)

blockNumber

The sequence of the block in the trigger model

branchToBlock

The block number of the trigger model block to execute when

the trigger model first encounters this block

Details

The branch-once building block branches to a specified block the first time the trigger model encounters the

branch-once block. If it is encountered again, the trigger model ignores the block and continues in the normal

sequence.

The once block is reset when the trigger model reaches the idle state. Therefore, the branch-once block always

executes the first time the trigger model encounters this block.

Example

trigger.model.setblock(2, trigger.BLOCK_BRANCH_ONCE, 4)

When the trigger model reaches block 2, the trigger model goes to block 4 instead of going in the default

sequence of block 3.

Also see

Once (on page 3-100)

Keithley 2450 User Manual

Other manuals for Keithley 2450