Interactive SourceMeter® Instrument Reference Manual Section 8:
2450-901-01 Rev. B/September 2013 8-211
trigger.model.setblock() — trigger.BLOCK_NOTIFY
This function defines a trigger model block that generates a trigger event and immediately continues to the next
block.
Type TSP-Link accessible Affected by Where saved Default value
Instrument reset
Usage
trigger.model.setblock(blockNumber, trigger.BLOCK_NOTIFY, trigger.EVENT_NOTIFYN)
The sequence of the block in the trigger model
The notify event that is generated (1 to 8)
Details
When the trigger model reaches a notify block, the instrument generates a trigger event and immediately
continues to the next block.
You can define up to eight notify blocks in a trigger model. You can reference the event that the notify block
generates by other commands to assign a stimulus somewhere else in the system. For example, you can use
the notify event as the stimulus of a hardware trigger line, such as a digital I/O line.
Example
digio.line[3].mode = digio.MODE_TRIGGER_OUT
trigger.model.setblock(5, trigger.BLOCK_NOTIFY, trigger.EVENT_NOTIFY2)
trigger.digout[3].stimulus = trigger.EVENT_NOTIFY2
Define trigger model block 5 to be the notify 2 event. Assign the notify 2 event to be the stimulus for digital
Also see
Notify building block (on page 3-97)
To Next Page
Loading...
Need help?
General
