Interactive SourceMeter® Instrument Reference Manual Appendix C:
2450-901-01 Rev. B/September 2013 C-3
Standard Event Register
The Standard Event Register set includes two 8-bit registers:
• Standard Event Status register: Reports when a predefined event has occurred. The register
latches the event and the corresponding bit remains set until it is cleared by a read.
• Standard Event Status Enable register: You can enable or disable bits in this register. This
allows the predefined event (from the Standard Event Status Register) to set the ESB of the
Status Byte Register.
Figure 150: Model 2450 Standard Event Register
To Next Page
Loading...
Need help?
General
