To Next Page

To Previous Page

Section

8: TSP command reference Model 2450 Interactive SourceMeter® Instrument

Reference Manual

8-110 2450-901-01 Rev. B/September 2013

smu.measure.limit[Y].low.value

This command specifies the lower limit for limit tests.

Type TSP-Link accessible Affected by Where saved Default value

Attribute (RW) Yes

Restore configuration

Instrument reset

Power cycle

Measure configuration list

Function change

Configuration script

Measure configuration list

−1.000000E+00

Usage

value = smu.measure.limit[Y].low.value

smu.measure.limit[Y].low.value = value

value

The high value; range is −999999900000 to

999999900000

Limit number: 1 or 2

Details

This command sets the lower limits for the limit tests for the selected measurement function. When limit Y testing

is enabled, this causes a fail indication to occur when the measurement value is less than this value.

Example

See the example in smu.measure.limit[Y].fail (on page 8-107).

Also see

smu.measure.limit[Y].enable (on page 8-106)

Keithley 2450 User Manual

Other manuals for Keithley 2450