Interactive SourceMeter® Instrument Reference Manual Section 2:
2450-901-01 Rev. B/September 2013 2-11
Interactive swipe screens
The Model 2450 touch-screen display has multiple screens that you can access by gently swiping left
or right on the lower half of the display. The following topics describe each of these screens.
SETTINGS swipe screen
The SETTINGS screen gives you front-panel access to some instrument settings so that you can
change, enable, or disable them quickly. It also shows what the present settings are.
Figure 5: SETTINGS swipe screen
To disable or enable a setting, select the box next to the setting so that it shows an X (disable) or a
check mark (enable).
Setting Description
Shows the present type of the filter (repeating average or
moving average).
Shows the present math function (percent, reciprocal, or
y = mx+b).
Shows the present value of the relative offset function.
Sets the instrument so that it automatically returns the
source to a zero value before taking another reading.
Sets the number of power line cycles (0.01 to 10.00).
Sets the number of digits visible on the display (3 to 6).
Turns autoranging on or off.
Moves the autorange setting up or down a level. Press
the up arrow to move up a range; press the down arrow
To Next Page
Loading...
Need help?
General
