To Next Page

To Previous Page

Model 2450

Interactive SourceMeter® Instrument Reference Manual Section 6:

SCPI command reference

2450-901-01 Rev. B/September 2013 6-155

:TRIGger:LAN<n>:IN:EDGE

This command sets the trigger operation and detection mode of the specified LAN event.

Type Affected by Where saved Default value

Command and query

LAN trigger <n> reset

Recall settings

Save settings

Nonvolatile memory

EITH

Usage

:TRIGger:LAN<n>:IN:EDGE <mode>

:TRIGger:LAN<n>:IN:EDGE?

<n>

The LAN event number (1 to 8)

<mode>

The trigger mode; see the Details for more information

Details

This attribute controls the mode in which the trigger event detector and the output trigger generator operate on

the given trigger. These settings are intended to provide behavior similar to the digital I/O triggers.

LAN trigger mode values

Mode Trigger packets detected as input LAN trigger packet generated for output with a…

EITHer

Rising or falling edge (positive or negative state)

negative state

FALLing

Falling edge (negative state)

negative state

RISing

Rising edge (positive state)

positive state

Example

:TRIG:LAN2:IN:EDGE FALL

Set the LAN trigger mode for event 2 to falling.

Also see

Digital I/O (on page 3-62)

TSP-Link System Expansion Interface (on page 3-118)

Keithley 2450 User Manual

Other manuals for Keithley 2450