To Next Page

To Previous Page

Section

8: TSP command reference Model 2450 Interactive SourceMeter® Instrument

Reference Manual

8-208 2450-901-01 Rev. B/September 2013

trigger.model.setblock() — trigger.BLOCK_LOG_EVENT

This function allows you to log an event in the event log when the trigger model is running.

Type TSP-Link accessible Affected by Where saved Default value

Function

Yes

Restore configuration

Instrument reset

Power cycle

Configuration script

Not applicable

Usage

trigger.model.setblock(blockNumber, trigger.BLOCK_LOG_EVENT, eventNumber, message)

blockNumber

The sequence of the block in the trigger model

eventNumber

The event number:

• trigger.LOG_INFON

• trigger.LOG_WARNN

• trigger.LOG_ERRORN

Where

is 1 to 4; you can define up to four of each type

message

A string up to 31 characters

Details

This block allows you to log an event in the event log when the trigger model is running. Insert the block into the

trigger model. When the trigger model executes the block, the event is logged.

Note that using this block too often in a trigger model could overflow the event log. It may also take away from

the time needed to process more critical trigger model blocks.

Example

trigger.model.setblock(1, trigger.BLOCK_LOG_EVENT, trigger.LOG_INFO1, "info

message")

Set trigger model block 1 to log an event.

Also see

None

Keithley 2450 User Manual

Other manuals for Keithley 2450