Keithley 2450 User Manual

Section
6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
6-160 2450-901-01 Rev. B/September 2013
Details
This attribute specifies which event causes a LAN trigger packet to be sent for this trigger. Set the event to one
of the existing trigger events, which are shown in the following table.
Setting this attribute to none disables automatic trigger generation.
If any events are detected before the trigger LAN connection is sent, the event is ignored and the action overrun
is set.
Trigger events
Event description Event constant
No trigger event
NONE
Front-panel TRIGGER key press
DISPlay
Notify trigger block <n>
(1 to 8) generates a trigger event
when the trigger model executes it
NOTify<n>
A command interface trigger occurred:
• Any remote interface: *TRG
• GPIB only: GET bus command
• VXI-11: VXI-11 command
device_trigger
COMMand
Line edge (either rising, falling, or either based on the
configuration of the line) detected on digital input line
<n> (1 to 6)
DIGio<n>
Line edge detected on TSP-Link synchronization
line
<n>
(1 to 3)
TSPLink<n>
Appropriate LXI trigger packet is received on LAN trigger
object
<n>
(1 to 8)
LAN<n>
Trigger event blender <n> (1 to 2), which combines
trigger events
BLENder<n>
Trigger timer <n> (1 to 4) expired
TIMer<n>
Source limit condition occurs
SLIMit
Example
TRIG:LAN1:OUT:STIM TIM1
Set the timer 1 trigger event as the source for the
LAN packet 1 trigger stimulus.
Also see
:TRIGger:LAN<n>:OUT:CONNect:STATe (on page 6-157)

Keithley 2450 Specifications

General

Brand	Keithley
Model	2450
Category	Test Equipment
Language	English