Polycom realpresence group series Administrator's Guide

• Connect one end of an HDMI cable to the HDMI Input port on the monitor. Connect the other
end of the HDMI cable to the Monitor 2 HDMI Output port on the system.
• If your monitor has only a DVI input port, use a DVI-HDMI adaptor to connect it to the HDMI
output port of the system.
2. Connect the touch monitor to the system.
If you are using a Polycom UC Board sensor with your current content monitor, the sensor is
connected to the system.
a. Connect one end of a USB cable to the USB port on the touch monitor.
b. Connect the other end of the USB cable to the USB port on the system.
A USB storage device can also be installed in the second USB port on the system for
importing and exporting slides, images, or photos.
3. To connect cables from the monitor 2 or the touch monitor to the system, refer to the next figure.
Adding a Polycom SoundStation IP 7000 Conference
Phone
When you connect a Polycom SoundStation IP 7000 conference phone to a RealPresence Group Series
system, the conference phone becomes another way to dial audio or video calls. The conference phone
also operates as a microphone, and as a speaker in audio-only calls. For more information, refer to the
following documents at Polycom Support:
• Polycom SoundStation IP 7000 Conference Phone Connected to a Polycom RealPresence Group
System in Unsupported VoIP Environments Integration Guide
• Polycom SoundStation IP 7000 Conference Phone Connected to a Polycom RealPresence Group
System in Unsupported VoIP Environments User Guide
Setting Up System Hardware
Polycom, Inc. 26

Polycom realpresence group series Specifications

General

Brand	Polycom
Model	realpresence group series
Category	Conference System
Language	English