Polycom realpresence group series Administrator's Guide

Indicator Light Connection Status
Left light green 1000Base-T connection.
Right light off No 10/100 Base-T connection and no network traffic
with 1000 Base-T connection.
Right light on 10/100 Base-T connection and blinks with network
traffic.
Right light blinking Network traffic.
Configure LAN Properties
You can configure LAN properties for your system in the local interface or the system web interface.
Procedure
1. In the system web interface, go to Admin Settings > Network > LAN Properties.
2. Configure the following LAN Options settings in the system web interface at Admin Settings >
Network > LAN Properties > LAN Options.
Setting Description
Host Name
(system web interface only)
Indicates your system name. If the system discovers a
valid name during setup or a software update, the
system automatically creates the hostname. However,
if an invalid name is found, such as a name with a
space, the system creates a hostname using the
following format: SystemType-xxxxxx, where
xxxxxx is a set of random alphanumeric characters.
IPv4 networks: The system sends the host name to
the DHCP server to attempt to register the name with
the local DNS server or look up the domain where the
system is registered (if supported).
IPv6 networks: You can leave this field blank since the
system doesn’t support this function. However,
Polycom recommends configuring the field to contain
the registered host name.
Domain Name
(system web interface only)
Identifies the domain your system belongs to.
If the system doesn’t automatically obtain a domain
name, optionally enter one here.
Configuring Network Settings
Polycom, Inc. 58

Polycom realpresence group series Specifications

General

Brand	Polycom
Model	realpresence group series
Category	Conference System
Language	English