SD Card Appli Move
SM 5-23 D037/D038/D040/D041
System
Maintenance
Reference
4. Remove the inner cover ( Section: Inner Cover in the Replacement and Adjustment).
5. Keep the SD card in the place [A] inside the inner cover after you have copied the
application program from one card to another card. This is done for the following
reasons:
1) The SD card can be the only proof that the user is licensed to use the
application program.
2) You may need to check the SD card and its data to solve a problem in the
future.
5.6.2 MOVE EXEC
The menu “Move Exec” (SP5-873-001) lets you copy application programs from the original
SD card to another SD card.
Do not turn ON the write protect switch of an application SD card on the machine.
If the write protect switch is ON, a download error (e.g. Error Code 44) occurs
during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that an SD card is in SD Card Slot 1. The application program is copied into
this SD card.
3. Insert the SD card (having stored the application program) to SD Card Slot 2. The
application program is copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 “Move Exec.”
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2.
10. Turn the main switch on.
11. Check that the application programs run normally.
5.6.3 UNDO EXEC
The menu “Undo Exec” (SP5-873-002) lets you copy back application programs from an
SD card to the original SD card. You can use this program when, for example, you have
mistakenly copied some programs by using Move Exec (SP5-873-001).
Do not turn ON the write protect switch of an application SD card on the machine.
If the write protect switch is ON, a download error (e.g. Error Code 44) occurs
To Next Page
Loading...
Need help?
General
