Card Save Function
D037/D038/D040/D041 5-36 SM
5.11 CARD SAVE FUNCTION
5.11.1 OVERVIEW
Card Save:
The Card Save function is used to save print jobs received by the printer on an SD
card with no print output. Card Save mode is toggled using printer Bit Switch #1 bit
number 4. Card Save will remain enabled until the SD card becomes full, or until all file
names have been used.
Captures are stored on the SD card in the folder /prt/cardsave. File names are
assigned sequentially from PRT00000.prn to PRT99999.prn. An additional file
PRT.CTL will be created. This file contains a list of all files created on the card by the
card save function.
Previously stored files on the SD card can be overwritten or left intact. Card Save SD
has “Add” and “New” menu items.
Card Save (Add): Appends files to the SD Card. Does not overwrite existing files.
If the card becomes full or if all file names are used, an error will be displayed on
the operation panel. Subsequent jobs will not be stored.
Card Save (New): Overwrites files in the card's /prt/cardsave directory.
Limitation:
Card Save cannot be used with PJL Status Readback commands. PJL Status
Readbacks will not work. In addition they will cause the Card Save to fail.
5.11.2 PROCEDURE
For D038/D041
1. Turn the main power switch OFF.
2. Insert the SD card into slot 2. Then turn the power ON.
3. Enter SP mode.
4. Select the “Printer Sp”.
5. Select SP-1001 "Bit Switch”.
To Next Page
Loading...
Need help?
General
