4WD Gear Shift Lever
Check lower end of gear shift lever where gear
shift fork shaft contacts
@
for wear and any
kind of damage. Worn or damaged shift lever
must be replaced with new one.
14-8. REASSEMBLY
NOTE:
l All parts to be used in reassembly must be
perfectly clean.
l Oil or grease sliding and rubbing surfaces of
transfer components just before using them
in reassembly with gear oil and SUZUKI
SUPER GREASE A (99000-25010).
l
Oil seals, “0” rings, gaskets and similar sealing
members must be in perfect condition. For
these members, use replacement parts in
stock.
l Tightening torque is specified for important
fasteners
-
mainly bolts
-
of transfer and
other components. Use torque wrenches and
constantly refer to specified data given in
P. 14-23.
Fig. 14-42
Input Shaft
Press-fit bearings onto both sides of input shaft
by using bearing installer (special tool).
Bearing installer (A) :
(09913-84510)
(A)
Fig. 14-43
14-14
To Next Page
Loading...
Need help?
General
