Data Collection and Analysis 771
Using the manual trigger to start the collection
1. Save and close any open documents.
When performing experiments it is recommended that you have only
one document open. The system cannot determine which of the
documents to use with the sensor if multiple documents are open.
2. Attach a sensor to the TI-Nspire™ Lab Cradle.
3. Attach the TI-Nspire™ Lab Cradle to the computer or handheld.
4. Set up your experiment as desired.
5. Navigate to Experiment > Advanced Set Up > Remote Collection
> TI-Nspire Lab Cradle.
6. Review the settings. Verify the delay is at zero (no delay).
Setting the delay at zero allows you to use the manual trigger button
on the lab cradle to start your collection.
7. Select OK.
A message displays stating the device is ready for remote collection.
To Next Page
Loading...
Need help?
General
