Note
This is a system setting that is applied to all jobs set to the System Specified output location. A status
message appears when this feature is active.
This feature is most useful when:
• Small sets of two or three pages are printed
• Order does not matter
• Productivity is important
Toggle the Alternate Sets Between Stackers feature by doing the following:
1. Logon to the FreeFlow Print Server as a System Administrator.
Note
Accessing the User Diagnostics mode pauses the printer.
2. Select System and User Diagnostics.
3. From the left navigation bar, select System Optimization Customer Setup.
4. Select an auto switching behavior option under Stacker Auto Switching Rules.
5. Select OK to apply the setting.
6. Select File and Close.
7. Resume the printer.
Explore the links below to learn all of the ways to utilize the BFM
Delivering Document Sets to the Stacker
Using Offset to Separate Documents in a Stack
Replacing Staples in the BFM
Clearing Stapler Jams
Clearing Paper Jams
Using DFA Compliant Finishers through the
DS3500/XPS
If you have a 3rd party finisher attached to your system, you will also have a DS3500/XPS. The
DS3500/XPS is an interface between the main printing area of the Xerox Nuvera EA Production System
or Xerox Nuvera 200/288/314 EA/MX Perfecting Production System and a DFA-compliant finishing
device of some type, such as a stapler, binder, booklet maker or folder.
14-21Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
How Do I...
To Next Page
Loading...
Need help?
General