Xerox Nuvera User Manual

• The BFM Plus Top Tray with Direct Connect is comprised of the Bypass BFM with an Interface
Module that has Top Tray capabilities and is able to connect directly to a DFA-compliant finisher(s).
The DFA-compliant finishers are limited to devices that have an 860mm height, Center registration,
and a velocity of 1130mm/s.
Using the BFM
Go to Using the Basic Finishing Module (BFM) for information on how to use the BFM and all of the
adjustments that affect the BFM.
Capacities
Stacker
• 3,000 sheets total capacity of 20 lb. (75-80 gsm) paper or equivalent.
• The stack limit can be set from the UI for each BFM independently.
• Stapled sets with <15 sheets are limited to 100 sets.
• It can staple up to 100 sheets of 8.5 x 11 inch or A4 LEF, and 8.5 x 14 inch or B4 SEF of 20 lb. (75-80
gsm). Portrait, landscape, and dual position stapling are available
• The Stacker is the output tray for receiving compiled stapled and unstapled sets as well as single
sheets. Output is normally delivered with side-1 down and sets can be offset.
• You can use a combination of 3 finishers maximum.
Top Tray
• 250 sheets of 20 lb. (75-80 gsm) paper or equivalent.
• Output to the Top Tray is delivered with Side-1 down and sets are not offset.
• It can be set as a destination tray for non-stapled jobs.
• Sheets less than 7 inches in the process direction or 8 inches in the cross-process direction will
automatically go to the Top Tray. The Top Tray also receives sheets that are purged from the system.
• Paper size greater than 18.5 inches in the process length will run to the top tray only.
Stapler
• The Basic Finishing Module has two internal pass-through 100 sheet up side down staplers. The
stapler devices have the ability to portrait, landscape or dual staple all paper sizes between 5.5"x8.5";
/ A5 and 12.6"x18.5 inches. Finished sets can be stacked internally to the lower stacker tray.
• These staplers have the capability of stapling 100 sheets of 20lb. (75-80 gsm) or equivalent substrates
(reduced stapled sheet capabilities can result based on substrate properties (i. e. thickness, density,
material, coating, etc.).
• If either of the Staplers runs out of staples see Replacing Staples in the BFM or if it jams see Clearing
Stapler Jams.
• An alternate Staple Cartridge is available with 30 sheets of 20lb. (75-80 gsm) paper capacity.
Contacting Xerox for information on ordering refills.
• Each Stapler Cartridge holds 5000 staples. Contacting Xerox for information on ordering refills.
Xerox
®
Nuvera
®
21-18
User Guide and Training Aid (UGTA)
Machine Specifications

Xerox Nuvera Specifications

General

Brand	Xerox
Model	Nuvera
Category	Printer
Language	English