Xerox Nuvera User Manual

The system will then begin an orderly startup. Wait several minutes for the system to load all services
before clicking anywhere in the user interface.
Method B: Shut down the system
1. In the user interface, click System > Shutdown.
2. Click Yes to shut down the system in an orderly fashion, after all scheduled jobs are processed.
3. Click Interrupt to shut down the system without completing the processing of current jobs.
4. Click No to return to the user interface.
5. In a few moments, the system will begin an orderly shutdown.
6. Once the system has completely shutdown, wait 30 seconds and power on the system by pressing
(I) on the power switch located on the lower right corner of the control console.
Using the Pass Through Mode Feature
The Pass Through Mode (PTM) is only available on the Xerox Nuvera 200/288/314 EA/MX Perfecting
Production System, which is uniquely configured with two print engines instead of one.
The PTM feature is used to maximize print productivity in the event that only one of the print engines
is up and running. If a print engine is shut down due to a fault, image quality mismatching, or pending
maintenance, the PTM feature allows you to identify the print engine to use for continued printing of
simplex or duplex jobs. The other print engine will only be used to pass paper through the system.
Note
When printing with one print engine, the productivity rate changes from 200/288/314 ipm to
100/144/157 ipm. To always make full use of the system's productivity, make sureto disable this feature
once the idle print engine is serviced and available for use.
When to enable Pass Through Mode
The following are the circumstances under which you would enable this feature and print with only one
print engine:
• One of the print engines is out of toner
• Required maintenance on one of the print engines is awaiting service (for example, the photo receptor
belt needs to be replaced)
• Certain print engine faults or system faults
• The image quality between the two print engines does not match and you want to use the print
engine that produces consistent image quality
If you encounter the following circumstances, contact Service. Do not use or enable this feature if the
system is experiencing:
• Reoccurring jams
• Critical print engine problems
• Certain print engine faults
• Registration faults
Xerox
®
Nuvera
®
16-4
User Guide and Training Aid (UGTA)
Maintaining Your Xerox Nuvera

Xerox Nuvera Specifications

General

Brand	Xerox
Model	Nuvera
Category	Printer
Language	English