7. Close the Booklet folding drawer (Area 4) in the MFF.
8. Rotate the handle (Area 2) to the down position.
Replacing the Fuser Web Cassette
The Fuser Web Cassette is not a customer replaceable unit monitored by the machine software. When
the web material is near end, a fault code will display.
1. When the faults 10-2180 Web Stall and 10-9105 Web EOL displays three or four times before
changing the Fuser Web Cassette.
2. Replacement instructions are on the Web Cassette package.
Replacing Staples in the BFM
There are two stapler cartridge sizes available for the Basic Finishing Module (BFM), a 30 or 100 page
staple cartridge.
Note
The stapler cartridge in the BFM Plus can be replaced if the BFM Plus is running in bypass mode.
Caution
Do not open the BFM front door and the stapler door at the same time.
To Replace BFM Stapler Cartridges
1. In the user interface, select Printer, then select Unlock Finisher.
The Unlock Basic Finisher window appears.
2. In the Stapler Drawer field, click Unlock .
You should hear the drawer mechanism click.
3. At the BFM, pull out the stapler drawer.
4. Remove the cartridge to be replaced by grasping the colored handle and pulling away from the
stapler mechanism.
Refer to the label on the stapler drawer for detailed removal instructions.
5. Replace new cartridge.
6. At the BFM, push in to close the stapler drawer.
7. In the Unlock Basic Finisher window, the Stapler Drawer field should now display Locked.
8. In the Unlock Basic Finisher window, click Close.
Note
The current machine software does not distinguish between the 30 Sheet Stapler Cartridge and the 100
Sheet Stapler Cartridge. If the 30 Sheet Stapler Cartridge is loaded in the machine, and a job with more
than 30 sheets is submitted for stapling, a mis-staple or stapler jam will probably occur. If the 30 Sheet
Stapler Cartridge is used, it is the responsibility of the operator to ensure that jobs exceeding 30 sheets
are not submitted for stapling.
15-7Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
Replacing Consumables