Xerox Nuvera User Manual

Special Case: Jobs with drilled paper AND drilled tabs when using the MFF
When processing jobs which use drilled paper and drilled tabs together, load the tabbed stock with tabs
trailing as usual, but load the drilled paper stock with the holes leading. This is contrary to what the label
on the tray depicts, but drilled stock must be loaded this way in order to achieve correct output. If the
job includes drilled tabs or drilled paper, but not within the same job, follow the diagram on the tray
label and/or the information in the table above.
Systems with SFM Insertion Module and MFF Professional
Note
No tabs can be loaded into an SFM Insertion Module (if present) if using a Multifunction Finisher.
LoadingStock Type
Holes trailing
Trays 1 and 2Drilled paper
Holes trailingTrays 3 and 4
Label side upTrays 1 and 2Labels
Label side upTrays 3 and 4
Tabs trailing (loaded into pre-fuser
FM only)
Trays 1 and 2Tabs
Tabs trailing (loaded into pre-fuser
FM only)
Trays 3 and 4
Face up, right edge leadingTrays 1 and 2Preprinted stock
Face up, right edge leadingTrays 3 and 4
Tape edge trailingTrays 1 and 2Transparencies
Tape edge trailingTrays 3 and 4
Face up, right edge leading, 1-N orderTrays 1 and 2Ordered stock
Face up, right edge leading, 1-N or-
der
Trays 3 and 4
Systems with MFF Pro Plus ONLY
LoadingStock Type
Holes trailing
Trays 1 and 2Drilled paper**
Holes trailingTrays 3 and 4
Holes trailingInsertion Tray
11-9Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
Setup Paper Trays

Xerox Nuvera Specifications

General

Brand	Xerox
Model	Nuvera
Category	Printer
Language	English