What is the length of the Control Head Harness?
Sta. 1 Sta. 2 Sta. 1 Sta. 2
Sta. 3 Sta. 4 Sta. 3 Sta. 4
Sta. 5 Sta. 5
Table F-226-3: Power Supply
Processor Information Port Stbd
What is the source of Processor power and how is it charged?
Is there a backup power supply? APS or other, explain. Yes No Yes No
Are the power cables protected by 10 Ampere Circuit Breakers? Yes No Yes No
What is the Voltage when not being charged?
Battery Processor Battery Processor
What is the Voltage when connected to Shore Power?
Battery Processor Battery Processor
What is the Voltage when the engines are running?
Battery Processor Battery Processor
Table F-226-4: Dock Trials
Processor Information Port Stbd
Does the engine start remotely when the Control System is turned OFF? Yes No Yes No
Does the Engine Stop Switch function at all Stations, regardless of RPM? Yes No Yes No
Can all Remote Stations take command? Yes No Yes No
Does the Warm-up Indicator Light blink in Ahead? Yes No Yes No
What is the Low Idle RPM? RPM RPM
High Idle RPM (optional) RPM RPM
Does the vessel surge forward with Control Head lever in the Ahead Detent? Yes No Yes No
Table F-226-5: Record at Dock
Processor Information Port Stbd
Throttle in Neutral (Cummins Quantum only) VDC, mA., Hz. or %
Throttle Minimum VDC, mA., Hz. or %
Throttle Maximum VDC, mA., Hz. or %
Troll Minimum (signal) mA
Troll Maximum (signal) mA
Table F-226-2: Processor Information
Processor Information Port Stbd
To Next Page
Loading...
Need help?
General
