Preface
ClearCommand Processor List
The processors for the systems listed below have software which includes several featured options.
Information about these options is contained in this manual, along with all standard instructions for 9000
series Processors. All vessels with ClearCommand Processors will not necessarily use all the featured options.
Decide on their utility based upon your application.
Below is an example of the 9000 Series Part Numbering system. This is just a guide, there are more options
available than shown below.
For example a 91212 is a ClearCommand Processor with Mechanical Engine, Solenoid Clutch, Mechanical
Troll and 2 stations. Each number in the part number signifies a different quality of the processor that fits your
needs. The last number in each Processor part number is the number of stations that are being used.
Available Options for the Processors Covered in this Manual
• Dynamic Positioning Interface
• Station 4 / Joystick Interface
• CANtrak Display
• Engine Room/Remote Switch (Station 1 only)
• Station 2 Lockout
• Speed Boost — Loaded w/Software
• Fixed Neutral Delay — Loaded w/Software
IMPORTANT: Keep this manual in a safe place for future reference. It contains essential information about the
installation and operation of the ZF Marine Propulsion Systems Miramar control system for your vessel.
9000 Series Part Numbering / Identification Guide
Part Number
90010 91000 91102 91202
91212 92000 92102 92112 92212 95232 96232
Engine /
Throttle
None 0 X
Mechanical 1 XXXX
Electrical 2
XXXX
Premium Mechanical 5
X
Premium Electrical 6
X
Gear /
Clutch
None 0 XX
X
Mechanical 1 X
XX
Solenoid 2 X
X XX X
Mechanical Gear /
Solenoid 2 Speed
3
Solenoid Gear /
Solenoid 2 Speed
4
Troll
None 0 XXX
XX
Mechanical 1 X
XX
Solenoid 2
Autotroll 3 XX
Mechanical Governed
Troll
5
Solenoid Governed
Troll
6
To Next Page
Loading...
Need help?
General
