Conventional Symbols Used in the Manual
Throughout this manual special attention should be paid to the following symbols.
Important Information
WARNING: Personal Injury may result if this message is disregarded.
CAUTION: Damage to equipment may occur if this message is disregarded.
IMPORTANT: Contains essential Information about a topic.
NOTE: Contains noteworthy information that may help to clarify a topic.
WARNING: Personal Injury could occur if the following steps are not followed exactly.
CAUTION: On Control Systems with more than one Processor, ZF Marine Propulsion Systems Miramar highly
recommends that ALL UNITS utilize the same software revision for each Processor.
CAUTION: Electro-static discharge can damage this equipment. Personnel working on this equipment must be
grounded to the chassis with an Anti-static Wrist Strap.
CAUTION: Disconnect the Power from the Processor whenever welding is being done on the vessel. Failure to
do so can cause permanent damage to the Processor.
CAUTION: This equipment is designed to work with other ZF Marine Propulsion Systems Miramar designed
equipment. DO NOT operate this equipment with any other manufacturers equipment unless approved so in
writing by ZF Marine Propulsion Systems Miramar Engineering Department.
To Next Page
Loading...
Need help?
General
