InteliLite 9 Global Guide
105
5.4.19 Sensor curves
Default sensor curves
There are 16 default resistive curves available. The following table provides information on minimum/maximum
values of respective sensors. Actual values especially of temperature curves may differ. Meaning is to prolong
curve to the lower temperature values, so the cold engine will not raise alarm fail sensor.
Curve Min [Ohm] Max [Ohm] Units
VDO 10 Bar 0-2400ohm 0 2400 Bar
VDO40-120°C0-2400ohm 0 2400 °C
VDOLevel%0-2400ohm 0 2400 %
General line 1 0 1000 ohm
General line 2 0 1000 ohm
General line 3 0 1000 ohm
General line 4 0 1000 ohm
General line 5 0 1000 ohm
General line 6 0 1000 ohm
General line 7 0 1000 ohm
General line 8 0 1000 ohm
General line 9 0 1000 ohm
General line 10 0 1000 ohm
General line 11 0 1000 ohm
General line 12 0 1000 ohm
General line 13 0 1000 ohm
Note: Curves can be modified via InteliConfig. In InteliConfig are also prepared some standard curves.
IMPORTANT: For right behavior of function, curve for this analog input has to be in percentage.
5.4.20 Tier 4 Final
Tier 4 Final support generally provides monitoring and control of after-treatment system installed on generators
engine. The requirements are defined as:
Providing After-Treatment status information by
displaying universal lamps (icons)
displaying analog and binary values
Control of After-Treatment regeneration function by
transmitting commands to the ECU
To Next Page
Loading...
Need help?
General
