InteliLite 9 Global Guide
90
Frequency
Generator Voltage Vg1 Generator voltage Ph1
Generator Voltage Vg2 Generator voltage Ph2
Generator Voltage Vg3 Generator voltage Ph3
Generator Voltage Vg12 Generator voltage Ph12
Generator Voltage Vg23 Generator voltage Ph23
Generator Voltage Vg31 Generator voltage Ph31
Generator Current Ig1 Generator current Ph1
Generator Current Ig2 Generator current Ph2
Generator Current Ig3 Generator current Ph3
Mains Voltage Vm1 Mains voltage Ph1
Mains Voltage Vm2 Mains voltage Ph2
Mains Voltage Vm3 Mains voltage Ph3
Mains Voltage Vm12 Mains voltage Ph12
Mains Voltage Vm23 Mains voltage Ph23
Mains Voltage Vm31 Mains voltage Ph31
Mains Frequency Mfrq Mains Frequency
Voltage Battery VBat Voltage of battery
Analog Input 1 Ain1 Analog input 1
Analog Input 2 Ain2 Analog input 2
Analog Input 3 Ain3 Analog input 3
Analog Input 4 Ain4 Analog input 4
Binary Inputs BIN Controller binary inputs
Binary Outputs BOUT Controller binary outputs
Controller Mode Mode Controller mode
Note: When some setpoint is changed, in history log is written its number of communication object.
5.4.12 Breaker control
The following power switches are controlled by the controller:
The generator circuit breaker or contactor – GCB
The Mains circuit breaker or contactor – MCB
It is possible to use either a motorized circuit breaker or contactor. Below is a list of available control outputs
that should fit all types of contactors or breakers. The following rules must be kept to when designing the wiring
of power switches:
The control outputs must be configured and wiring of the power switches must be provided in such a way,
that the controller has full control over the breakers – i.e. the controller can open and close the breaker at any
time.
The breaker must respond within max. 5 seconds to a close and open command. Special attention should be
paid to opening of motorized circuit breakers, as it could take more than 5 seconds on some types. In such
cases it is necessary to use an undervoltage coil for fast opening.
To Next Page
Loading...
Need help?
General
